Manufactured from 77 mm curved galvanised steel lath 20swg
Galvanised steel T-section bottom rail
Galvanised 75mm X 25mm X 3mm mild steel guides
Constructed to Exova Warrington Fire test certificate standard BSEN 1634-1
Hood/canopy support brackets may be required, depending on fire rating, size and weight
Electrically operated external chain drive motor available in 3 phase, 415 volts, 50Hz, or 1 phase, 240 volts, 50Hz
The motor is designed to de-clutch, allowing the shutter to gravity close in a fire situation at a controlled speed (option to power down)
Complete with emergency hand chain facility and rocker or key switch supplied as standard
Generally by auto solenoid release, linked to the fire alarm. The solenoid requires a 24 Volt DC, 0.55 Amps signal. This is the most commonly used method of activation, allowing for frequent testing and re-setting. When the shutter is returned to the open position (after removal of the fire signal), the solenoid can be automatically reset. A fusible link or localised smoke/heat detector (see back page for details) can be used as back-up to activate the shutter, or as an alternative if no fire alarm signal is available.
Obviously a fire alarm cannot activated to close or cover a fire exit area.
Galvanised self colour finish with one coat of primer paint on end plates, angles and barrel; can be polyester powder coated to any RAL or standard BS4800 colour.
General maximum sizes: 7000mm wide x 7000mm height any larger shutters please contact us to discuss your requirements
Please feel welcome to contact us over any matter that may occur to you. We are a friendly, approachable company and are more than willing to to help in any way.
Atex Certified Motors available in our Fire Shutters.
Manchester Office / Factory: 0161 272 9333.
London Office: 0207 873 2390.
West Midlands Office: 0121 285 0239.
East Midlands Office: 0115 8240036.
We manufacture our own Fire Shutters. The video below shows part of our manufacturing process.